Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions EN
CONTENTS
The jig is designed for cutting circles and ellipses at circumference or on the front side of the piece. It extends
the possibilities of the portable router and increases the quality of the machined surface as well as the
precision of the cut form. The basis of the whole jig system is the sliding cross frame made of special plastic.
Special sliders A + B are shifted within this cross frame.
PACKAGE CONTENTS
1 pc (1) Cross frame made of special plastic
2 pc (6) Guide rods D=10mm (upon request 8 mm ) L= 400 mm
2 pc (5) Distance rods with L =400 mm screw
1 pc (4) Distance rod L =400 mm
1 pc (3) Connector plate
2 pc (7) Control bolt M8
2 pc (2) Sliders - complete
1 pc (8) Imbus Screw M8x20
2 pc (12) Imbus Screw M5x16
2 pc (14) Screw M4x25 with countersink head
1 pc (10) Screw washer M8
2 pc (11) Screw washer M5
1 pc (9) Elastic screw washer M8
4 pc (13) Wood screw 4x35
JIG ASSEMBLY
(Fig. 7) Insert the guide rods D10 (6) into
the grooves of the connector plate (3)
and tighten with screws M5x16 (12) and
washers (11). Screw the control screw (7)
into the sliders (2). Put the sliders (2) into
the cross frame (1). Assemble the distance
rods D16 (5) and (4) together. Insert the
end of the distance rod with threading into
the groove of the connector plate (3) and
tighten with screw M8x20 (8) and washer
(9) and (10). Put the sliders A and B into the
guide grooves of the cross frame, insert the
distance rod into the holes in the pins of
both sliders, tighten the control screws of
the sliders. Assembly is now complete.
2
7.
PAGE
2
2
3
3
5
5
www.igmtools.com
www.igm.cz
Werbung
Kapitel
Inhaltsverzeichnis
