Herunterladen Inhalt Inhalt Diese Seite drucken

ACME BLIZZ 200 3D Anleitung Seite 20

Heli master
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Warning about low voltage
Discharging a LiPo battery below 3.5 V can damage it. It may no longer accept charge. Please land the helicopter immediately and recharge
its battery.
There is NO LiPo-Saver included in the helicopter!
Disconnect and remove the LiPo battery from the helicopter after use in order to prevent trickle discharge. Before storing it, charge the LiPo
battery to its full capacity. Whilst storing, make sure the battery charge does not go below 3.5 V.
Information and warnings
!
All instructions and warnings must be followed exactly. Mishandling the LiPo batteries can cause fi re, personal injury and/or property
damage. The battery charger included in the Blizz 200 3D set has been designed to charge the LiPo battery safely.
» By handling, charging or using the included LiPo batteries you accept all risks associated with lithium batteries.
» Immediately stop using the batteries if they start swelling or bulging. If you are charging or discharging the batteries, stop the process
and disconnect them from the power supply. If you do not stop using, charging or discharging a swelling battery it can cause a fi re.
» Always store the batteries at room temperature in a dry place.
» Make sure the battery is stored at a temperature between 5 °C and 45 °C, even if transporting it or storing it for a short time only. Never
store the battery or the model in a car or in direct sunlight. If left in a hot vehicle, the battery can be damaged or even catch fi re.
» Never use a Ni-CD or Ni-MH charger. Charging the battery with a non-compatible charger may cause fi re that could lead to personal injury
and/or property damage.
» Never exceed the recommended charge rate.
» Never cover up warning labels.
» Only use the power adapter included in the set.
» Only use the charger and adapter supplied by ACME the game company.
» Never attempt to power the charger from an AC outlet without the use of an adequate AC/DC adapter.
» Do not leave charged or discharged LiPo batteries connected to the charger if it is not connected to the adapter. Doing so will discharge
and can damage the batteries.
» Provide adequate ventilation while charging.
» Do not insert anything in the helicopter and keep enough distance while fl ying.
» Make sure that no water enters the components.
Downloaded from
www.Manualslib.com
3D HELI Master
manuals search engine
20

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis