Maytronics dolphin active classic Gebrauchsanweisung Seite 6

English
Turning the Robot Pool Cleaner ON
1. Plug the floating cable from
the Robot Pool Cleaner
into the power supply unit.
2. Plug the electrical cable
from the power supply
unit into the mains.
3. Press the ON / OFF switch.
4. The Robot Pool Cleaner
will now start to work.
Part 3 - Taking the Robot Pool Cleaner out of the water
Unplug power supply before any servicing activity.
1. If the Robot Pool Cleaner has not finished its cycle,
turn off the power supply unit and unplug the mains.
2. Pull the floating cable gently until the Robot Pool Cleaner
has risen to the surface, then lift by the handle.
Downloaded from 8151622.indd 4 www.Manualslib.com
Important: Do not enter the swimming pool while the pool cleaner is working.
Important: Do NOT lift the Robot Pool Cleaner from the water by its cable.
manuals search engine
Floating cable
On/Off
switch
4
29/01/13 1:04 PM