GreenWorks GD24AG Bedienungshandbuch Seite 4

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to grind metals and sand metal surfaces.
1.2 OVERVIEW
Figure 1.
On/Off switch
1
Spindle lock button
2
Direction arrow
3
Guard clasp
4
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 INSTALL THE BATTERY PACK
Figure 2.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
Clamp nut
5
Protection guard
6
Auxiliary handle
7
WARNING
WARNING
WARNING
WARNING
English
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3 REMOVE THE BATTERY PACK
Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4 INSTALL THE AUXILIARY
HANDLE
Figure 3.
The auxiliary handle must be used to help prevent loss of
control and possible injury.
The auxiliary handle can be installed on the left or right side
of the machine.
1. Install the auxiliary handle into the necessary position.
2. Turn the auxiliary handle clockwise to tighten.
4 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4.1 START THE MACHINE
Figure 4.
1. To start the machine, push the On/Off switch forward.
2. To lock the On/Off switch, push the On/Off switch down
at the front until it latches.
4.2 STOP THE MACHINE
Figure 5.
1. To stop the machine, release the On/Off switch or, if it is
locked, briefly push the rear of the On/Off switch and
then release it.
2. To keep energy, only switch the machine on when you
use it.
4
WARNING
WARNING
WARNING