Werbung
Verfügbare Sprachen
Verfügbare Sprachen
High power LED with 80 lux light output - for connection to direct current DC AC ,
EN
6- 48 V - not suitable for connection to dynamos - overvoltage protection - bracket
for mounting to the crown
MOUNTING
Connection
Controller
FUNCTION
1. Tested and approved in line with German national road traffic regulations.
2. The lamp must be firmly connected to the bicycle. The light distribution must not
be obstructed by any part of the vehicle.
3. Headlight must be mounted so that other road users will not be blinded.
4. For bicycles with electrical pedal assistance: the power supply of the lighting system
can optionally be connected to the battery, but only if a continuing power supply -
after the auxiliary drive has been switched off due to discharge - is guaranteed for at
least two hours and / or the drive motor can be used temporarily as an alternator to
continue the power supply of the lighting system.
5. The headlight is switched on and off via the external power supply.
6. Upon failure of the lightemitting diode, the complete lighting unit needs to be
exchanged.
white = plus (+), black = minus (-)
mounting
parallel to
the ground
90°
orientation orthogonal to
longitudinal axis
50%
approval number
(lamp)
approval number
(reflector)
5m
Keep for future reference!
mounting
height
400-
1,200 mm
Werbung
