Peavey Messenger Serie Betriebsanleitung Seite 8

O P E R A T
OPERATING INSTRUCTIONS
CAUTIONS
The unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to
qualified service personnel.
The heat sink on the back plate can become hot to the touch. Do not block or cover the heat sink from ventilation.
DO NOT connect the inputs of the PRO™ Sub P to the output of a power amplifier. The inputs are meant to be
driven from a line-level signal.
DO NOT remove the protective metal grille.
Warning! The PRO™ Sub P is very efficient and powerful! This sound system can permanently damage hearing!
Use extreme care when setting the overall maximum loudness!
The sound level of the PRO™ Sub P can be deceptive due to its clear, clean sound output. The lack of distortion or
obvious distress can make the sound level seem much lower than it actually is.
GETTING AC POWER TO THE PRO™ SUB P
The PRO™ Sub P comes with an IEC AC power cord. If you are using an extension cord or power strip with this
powered speaker, make sure it is of good quality and of a sufficient current capacity to maintain safety and
maximize the power output capability of the PRO™ Sub P. Do not connect any other device to the same extension
cord.
Downloaded from www.Manualslib.com manuals search engine