Water Connection - ZANKER ZKI1530 Benutzerinformation

If a repair is necessary, the appliance must be easily
accessible for the engineer.
Put the appliance adjacent to a water tap and a drain.
For the venting of the dishwasher only water fill, water
drain and power supply cable openings are necessary.
The dishwasher has adjustable feet to allow the adjust-
ment of the height.
Make sure that the water inlet hose, the drain hose and
the supply cable are not kinked or squashed, when you
insert the machine.
Attaching the appliance to the adjacent units
Make sure that the counter below which you attach the
appliance is a safe structure (adjacent kitchen units,
cabinets, wall).

Water connection

Water inlet hose
Connected the appliance to a hot (max. 60°) or cold
water supply.
If the hot water comes from alternative sources of ener-
gy that are more environmentally friendly (e.g. solar or
photovoltaic panels and aeolian), use a hot water sup-
ply to decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4".
Caution! Do not use connection hoses from an
old appliance.
The water pressure must be in the limits (refer to the
chapter 'Technical data'). Make sure that the local water
authority gives you the average mains pressure in your
area.
Make sure that there are no kinks in the water inlet
hose and that the water inlet hose is not squashed or
entangled.
Turn the inlet hose to the left or the right to suit the in-
stallation. Fit the locknut correctly to prevent water
leaks.
Caution! Do not connect the appliance to new
pipes or pipes that are not used for a long time.
Let the water run for some minutes, then connect the
inlet hose.
Water inlet hose with safety valve
The water inlet hose is a double-walled and has an in-
ner mains cable and a safety valve. The water inlet
hose is under pressure only while the water is running.
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal
the door correctly. If the level of the appliance is cor-
rect, the door does not catch on the sides of the cabi-
net. If the door does not close correctly, loosen or tight-
en the adjustable feet until the appliance is level.
If there is a leak in the water inlet hose, the safety valve
interrupts the running water.
Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in
water.
• If the water inlet hose or the safety valve is dam-
aged, immediately disconnect the mains plug from
the mains socket.
• Only let the Service Force Centre replace the water
inlet hose with safety valve.
Warning! Danger-
ous voltage
31