Inhaltsverzeichnis
Werbung
LITE
EN
Detailed instructions on the installation of power cables with access
Open the top right glove compartment cover and
1
remove the two screws from the bottom section.
(A)
1
A
Slightly separate the glove box and gather in the
2
original wiring by inserting your hand through the
lower side. This cabled line is protected by a 40
amp fuse in the original central fuse boxes.
If the existing terminal is already being used (for
!
example, connected to a microwave), add a new
terminal, similar to the existing one, from the
glove compartment to the central box.
Protect the power cable with a separate 40 Amp
fuse. (Set aside the 40 Amp. fuse in the central
fuse box).
Direct the cabled line of the unit between the roof
3
and the upholstery above the glove box and plug
in both connectors. Once connected, the unit will
carry out a test function; all the lights go on and
off, indicating that the unit is ready.
Secure the cabled line of the unit to the aluminium
support with plastic flanges, as shown in the
image.
IMPORTANT
If the cabled line is mistakenly connected with the polarity inverted, the electronic control in the unit will
beep. Do not touch any buttons on the panel or remote control, as this may produce irreparable damage
in the electronic system. If you hear these beeps, disconnect the unit and check the connection polarity.
through the top right glove compartment
1
2
3
20
Werbung
Inhaltsverzeichnis
