Troubleshooting - Onix XIA-160SE Bedienungsanleitung

Listening
1. Set the VOLUME control to minimum and press the power switch (POWER).
2. Set using the INPUT button on the desired audio source, each time the button is pressed, it changes
the audio source input.
3. Adjust the volume of the amplifier by using the VOLUME of the control.
Inputs
The amplifier has four RCA inputs (BYPASS, VIDEO, TUNER, SACD) for various audio components and one
XLR imput, the inputs VIDEO, TUNER, SACD have the same function, while the input BYPASS allows to use
the amplifier only as a power amplifier, not the preamplifier stage.
Protection
The device has a sophisticated protection circuit against the short circuits, distinguishing itself with the
simultaneous flashing of all LEDs for a few seconds, in this case must be unplugged the power cord and leave
unplugged for at least 15 minutes.

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong
with this component, check the points below. Sometimes the trouble may lie in another component. Investigate
the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest ONIX authorized
service center or your dealer to carry out repair work
.
Symptom
No power
supplied to unit
No sound
No sound from
one speaker
Power transistor Sanken C3264/A1295 for every channel; Filter capacitor Nichicon "Super Through"
4 x 10.000uF/80V; 4 x MUR Ultra fast recti er diodes; two high e ciency toroidal trasformers supplying power
to two channels independently 600VA; Motorized Alps "Blue Velvet" potentiometer.
Downloaded from www.Manualslib.com
Cause
Power plug is disconnected from outlet
Connecting cords are disconnected
from terminals, or connected
incorrectly
The position of the input selector does
not correspond to the component to be
played back.
Connecting cords or speaker cords
are disconnected on the side.
Components:
manuals search engine
Remedy
Check that power cord and insert the plug
securely into outlet
Check if connections between external device
and the amplifier are connected correctly.
Check if the LED of the input selector
corresponds to the input source that you want
to listen.
Verify that the cables between amplifier and
speaker are well- connected according to the
different polarity.
5