UNICA TERM ECO 6 Betriebs- Und Wartungshandbuch Seite 34

E N G
Display text
OFF
P1-P2-P3
10....30°C
AIR 1...9
CP-TS-PA
H1......H7
Bat1
When the stove is in stand-by mode, OFF
in MANUAL mode, or along with the set room temperature if the stove is in AUTOMATIC mode.
Only when the stove is brand-new or in case it is left completely without pellets, it may be necessary to
load the pellet conveyer system (auger) manually.
To do this, press the button
automatically after 240 seconds, or by pressing the
Press the
AC
step will take a few minute to complete, and will ensure that the ignition and warm-up processes are
performer correctly.
After a few minutes, the stove will start the internal heating *warm up( process and
displayed. Subsequently, the room heating process will be initiated and the set intensity level or room
temperature will be displayed according to whether the manual or automatic mode is selected.
3 4
Downloaded from www.Manualslib.com
1.2 DISPLAY TEXT KEY
Meaning
Shut-down process initiated; duration about 10 minutes
AC First starting-process phase; pellets being loaded, awaiting flame ignition
AR Second starting-process phase; operating intensity being reached
PH Heat exchanger warming up
Intensity level setting
Room temperature setting
Fan speed setting
Pu Automatic firebox cleaning
SF Unexpected unit stop, probably due to no pellets left in the hopper
Control menu only available to tecnica assistance centres
AF Pellets ignition failed
System failure; each number indicates a different failure cause
No clock battery left (CR2032)
2.0 MANUAL AUGER LOADING
3.0 STARTING PROCESS
button while the stove is in stand-by mode. The starting process will now start.
will be displayed; after some routine checks and the ignition check, AR
manuals search engine
will be displayed along with the set intensity level if the stove is
together; ri will be displayed. The process will terminate
button.
will be displayed this
PH will be