Software Updates; Set Up Usb Communications Hub - Oregon Scientific Adviser II I600 Bedienungsanleitung

7. Click Apply to begin the registration.
8. Click OK.
9. In webpage, click QUIT.
To learn more about how to utilize the functions available
on the software, please refer to PC Software Manual,
downloadable from the software webpage.
IMPORTANT
software to access this.
1. Click on MENU located at the top right hand corner
of software main webpage.
2. Select HELP from drop-down list. This will redirect
you to a new webpage. Click on
Manual.

SOFTWARE UPDATES

As we continually strive for improvement, the software
will be updated from time to time.
If there is a new version, the moment PC is connected
to the internet, a dialogue box informing of available
software will appear.
1. Click OK.
2. After a few moments, File Download - Security
Warning dialogue box will appear. Click Run.
3. In the Internet Explorer - Security Warning, click
Run.
4. Follow steps 3 - 7 from Install Software section.
Downloaded from www.Manualslib.com
You must first successfully install
PC Software
manuals search engine

SET UP USB COMMUNICATIONS HUB

Approximately 30
computer is sufficient to receive current weather
data. For continuous use, always connect the USB
Communications Hub to the computer using the USB
cable provided.
1. Plug USB Cable into the USB port of the
Communications Hub and your computer.
2. The lit up red LED on the front of the USB
Communications Hub indicates Hub has been
properly connected to the computer.
There is a registration mode with the main unit when the
USB Communications Hub is turned on the first time, or
after each installation.
IMPORTANT Registration can take half an hour. Do
not turn off computer / disconnect USB from computer
during this time.
7
minutes daily connection to