Troubleshooting - D-Link DAP-1320 Installationsanleitung

TROUBLESHOOTING

1. HOW DO I RESET MY DAP-1320 WIRELESS RANGE EXTENDER N300 TO FACTORY
2. HOW DO I ADD A NEW WI-FI CLIENT OR PC IF I HAVE FORGOTTEN MY WI-FI NETWORK
TECHNICAL SUPPORT
United Kingdom (Mon-Fri) website: http://dlink.com
Home Wireless/Broadband 0871 873 3000 (9.00am–06.00pm, Sat 10.00am-02.00pm)
Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am- 05.30pm)
(BT 10ppm, other carriers may vary.)
Ireland (Mon-Fri)
All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm)
Phone rates: €0.05ppm peak, €0.045ppm off peak times
6
Downloaded from www.Manualslib.com
SETUP AND CONFIGURATION PROBLEMS
DEFAULT SETTINGS?
- Ensure the product is powered on.
- Press and hold the reset button on the bottom of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration
settings. The default Wi-Fi network name (SSID) and password are printed on
the D-Link DAP-1320 Wireless Range Extender N300's Wi-Fi Configuration
Card.
NAME (SSID) OR WI-FI PASSWORD?
-If you haven't changed the extended Wi-Fi network's settings, you can use the
network name (SSID) and Wi-Fi password on the Wi-Fi Configuration Card.
- If you did change the network name (SSID) or Wi-Fi password and you did not record
this information on the Wi-Fi Configuration Card or somewhere else, you must reset
the device as described in Question 1 above.
- Make sure you write down these settings so that you can enter them into each
wirelessly connected PC. You can use the included Wi-Fi Configuration Card to
record this important information for future use.
manuals search engine
DAP-1320