AEG TR3051TW Benutzerinformation Seite 21

Possible cause
Internal fail. No communication be‐
tween electronic elements of the
appliance.
E97
The mains supply is unstable.
EH0
If the display shows other alarm codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the Tumble dryer check the table below for possible
solutions.
12.2 Troubleshooting
Problem
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
Possible cause
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is
correct.
Make sure that the laundry is not caught be‐
tween the appliance door and the rubber
seal.
Make sure that the water container is emp‐
ty. Press Start/Pause to start the pro‐
gramme again.
Load is too small, increase the load or use
the Zeitprogramm (Time Drying) pro‐
gramme.
Remedy
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the alarm code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
ENGLISH 21