Doro RadioStreamer fmt300 Bedienungsanleitung Seite 19

3. Save frequencies
1. Use
2. Press
3. Select desired channel position (1-6) with
4. Press
5. Repeat steps 1-4 to save more stations.
4. Selecting stored frequency/channel position
1. Press
2. Use
FAQ
Why is there no sound?
1. Check that the mains/car adapter is connected correctly.
2. Check that the set frequency is the same on the
3. Ensure that the audio source and the FM radio are
How do I reduce interference?
1. Check that a local radio station is not interfering with the
2. Lower the volume of your audio source and use the FM radio
3. Make sure that your RadioStreamer is not located too close
4. If the radio cannot find the Radiostreamer's transmission,
In order to function, the appliance requires one high quality 1.5
V battery (AAA type, included) or the unit can be run from a 12
V socket. Please note that operating time will vary according to
the type of batteries being used.
Downloaded from www.Manualslib.com
/ to set desired frequency (87.6-107.9MHz).
once. MEMO will start to flash.
!
to save. The selected channel position starts to flash
!
and is now active. The selected channel position flashes as
long as it is active.
twice in quick succession. The current channel
!
position and frequency are shown on the screen.
to scroll between channel positions.
!
Check that the battery is not dead and needs to be changed.
RadioStreamer and the FM radio.
functioning correctly.
selected frequency. If this is the case – change to another
frequency.
to adjust the volume.
to units such as mobile phones or other electrical equipment.
These can interfere with transmission.
turn off the automatic channel search function on your radio.
manuals search engine
English
1
/ .