Herunterladen Inhalt Inhalt Diese Seite drucken

physa PHY-1100HD-1 Bedienungsanleitung Seite 3

Inhaltsverzeichnis

Werbung

4
Sicherheit zuständigen Person und nach einer
Einweisung in die Bedienung der Maschine gestattet.
c)
Vergewissern Sie sich vor dem Anschließen des
Geräts an eine Stromquelle, dass der Schalter
ausgeschaltet ist.
d)
Überschätzen Sie Ihre Fähigkeiten nicht. Sorgen Sie
für einen sicheren Stand während der Arbeit. Dies
gibt Ihnen eine bessere Kontrolle über das Gerät im
Falle unerwarteter Situationen.
e)
Das Gerät ist kein Spielzeug. Kinder sollten in der
Nähe des Geräts unter Aufsicht stehen, um Unfälle
zu vermeiden.
SICHERE ANWENDUNG DES GERÄTS
a)
Überhitzen Sie das Gerät nicht. Richtig ausgewählte
Geräte und der sorgsame Umgang mit ihnen führen
zu besseren Arbeitsergebnissen.
b)
Benutzen Sie das Gerät nicht, wenn der EIN-/AUS-
Schalter nicht ordnungsgemäß funktioniert. Geräte,
die nicht über den Schalter gesteuert werden können,
sind gefährlich und müssen repariert werden.
c)
Trennen Sie das Gerät vom Stromnetz, bevor Sie
Zubehör einstellen, auswechseln oder wenn Sie das
Gerät nicht mehr verwenden. Dies verringert das
Risiko einer versehentlichen Inbetriebnahme.
d)
Nicht
verwendete
Werkzeuge
sind
außerhalb
der Reichweite von Kindern sowie von Personen
aufzubewahren, welche weder das Gerät noch die
Anleitung kennen. In den Händen unerfahrener
Personen können diese Geräte eine Gefahr darstellen.
e)
Halten Sie das Gerät stets in einem einwandfreien
Zustand. Prüfen Sie vor jeder Inbetriebnahme, ob
am Gerät und seinen beweglichen Teilen Schäden
vorliegen (defekte Komponenten oder andere
Faktoren, die den sicheren Betrieb der Maschine
beeinträchtigen könnten). Im Falle eines Schadens
muss das Gerät vor Gebrauch in Reparatur gegeben
werden.
f)
Halten Sie das Gerät außerhalb der Reichweite von
Kindern.
g)
Reparatur und Wartung von Geräten dürfen
nur von qualifiziertem Fachpersonal und mit
Originalersatzteilen
durchgeführt
werden.
so wird die Sicherheit während der Nutzung
gewährleistet.
h)
Um
die
Funktionsfähigkeit
des
Gerätes
gewährleisten, dürfen die werksmäßig montierten
Abdeckungen oder Schrauben nicht entfernt werden.
i)
Beachten Sie bei Transport zwischen Lager und
Bestimmungsort und Handhabung des Gerätes die
Grundsätze für Gesundheits- und Arbeitsschutz des
Landes, in dem das Gerät verwendet wird. .
j)
Lassen Sie dieses Gerät während des Betriebs nicht
unbeaufsichtigt.
k)
Das Gerät muss regelmäßig gereinigt werden, damit
sich nicht dauerhaft Schmutz festsetzt.
l)
Lufteinlass und Luftauslass dürfen nicht verdeckt
werden.
m)
Das Gerät ist kein Spielzeug. Reinigung und Wartung
dürfen nicht von Kindern ohne Aufsicht durch eine
erwachsene Person durchgeführt werden..
n)
Es ist untersagt, in den Aufbau des Geräts
einzugreifen, um seine Parameter oder Konstruktion
zu ändern.
o)
Geräte von Feuer – und Wärmequellen fernhalten.
p)
Überlasten Sie das Gerät nicht.
ACHTUNG! Obwohl das Gerät mit dem Gedanken an
die Sicherheit entworfen wurde, besitzt es bestimmte
Schutzmechanismen.
Trotz
der
Verwendung
zusätzlicher Sicherheitselemente besteht bei der
Bedienung immer noch ein Verletzungsrisiko. Es wird
empfohlen, bei der Nutzung Vorsicht und Vernunft
walten zu lassen.
Nur
zu
LEGEND
The product satisfies the relevant safety
standards.
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER!
Applicable to the given situation (general
warning sign).
ATTENTION! Electric shock warning!
Class I protection.
ATTENTION! Hot surface, risk of burns!
Only use indoors.
WARNING! Do not use this appliance near
bathtubs, showers, sinks or other vessels
containing water.
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury or even death.
The terms "device" or "product" are used in the warnings
and instructions to refer to STANDING HAIR DRYER. Do not
use in very humid environments or in the direct vicinity
of water tanks. Prevent the device from getting wet. Risk
of electric shock! Do not cover air inlets / outlets! Do not
cover the ventilation openings!
ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the
plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes,
heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment.
Water getting into the device increases the risk of
damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it
to carry the device or to pull the plug out of a socket.
Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables
increase the risk of electric shock.
e)
Do not use the device if the power cord is damaged
or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or
the manufacturer's service centre.
f)
To avoid electric shock, do not immerse the cord,
plug or device in water or other liquids. Do not use
the device on wet surfaces.
g)
ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
h)
If using the device in a damp environment cannot
be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of
electric shock.
SAFETY IN THE WORKPLACE
a)
Make sure the workplace is clean and well lit. A messy
or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive
environment, for example in the presence of
flammable liquids, gases or dust. The device
generates sparks which may ignite dust or fumes.
c)
If you discover damage or irregular operation,
immediately switch the device off and report it to
a supervisor without delay.
d)
If you are unsure about whether the product is
operating correctly or if you find damage, please
contact the manufacturer's service centre.
e)
Only the manufacturer's service centre may make
repairs to the product. Do not attempt to make
repairs yourself!
f)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
g)
Children or unauthorised persons are forbidden to
enter a work station. (A distraction may result in loss
of control over the device).
h)
Use the device in a well-ventilated space.
i)
Regularly inspect the condition of the safety labels. If
the labels are illegible, they must be replaced.
j)
Please keep this manual available for future
reference. If this device is passed on to a third party,
the manual must be passed on with it.
k)
Keep packaging elements and small assembly parts
in a place not available to children.
l)
Keep the device away from children and animals.
REMEMBER! When using the device, protect children
and other bystanders.
PERSONAL SAFETY
a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which can
significantly impair the ability to operate the device.
b)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience
and/or knowledge unless they are supervised by
a person responsible for their safety or they have
received instruction on how to operate the device.
c)
To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
d)
Do not overestimate your abilities. When using the
device, keep your balance and remain stable at all
times. This will ensure better control over the device
in unexpected situations.
e)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
SAFE DEVICE USE
a)
Do not overload the device. Use the appropriate
tools for the given task. A correctly-selected device
will perform the task for which it was designed better
and in a safer manner.
b)
Do not use the device if the ON/OFF switch does not
function properly (does not switch the device on and
off). Devices which cannot be switched on and off
using the ON/OFF switch are hazardous, should not
be operated and must be repaired.
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Phy-1100hd-2

Inhaltsverzeichnis