Petra electric CoolCurl CC 1100 Gebrauchsanweisung Seite 9

Downloaded from www.Manualslib.com
Settings
Use the slide switch to adjust the heat and air
setting individually.
C Cooling mode
2 Maximum heat output
1 Medium heat output
0
Appliance is switched off
If the air outlets are covered or if they are blo-
cked with hair, the emerging air will get too hot
and the overheating protection will switch off
the appliance. In this event, set the switch to
-0-. After about 5 minutes the curling tong can
be put into operation again. If necessary, clean
the appliance when unplugged prior to starting
up again.
Brush attachments
Styling brush 25 mm Ø
’ ideal for styling small curls
Styling brush 38 mm Ø
’ ideal for styling medium-sized curls
Styling brush 50 mm Ø
’ ideal for styling voluminous hair and big curls
Depending on the length of your hair or the re-
quested hairstyle, choose the suitable brush.
When the unit has cooled off, press the unlo-
cking button to change the brush. Turn and pull
the brush counter-clockwise. Push on the new
brush and turn clockwise up to the stop.
After curling up your hair, permit the heat to take
effect for some seconds.
If the hot air is too hot, switch to a lower set-
ting.
Comb or brush the hair after it has cooled off
completely. The hairstyle will hold longer.
manuals search engine
DE
GB
9