AirLive WLA-5200AP Schnelleinrichtungsanleitung Seite 10

WISP+Universal Repeater Mode
Device B:
WISP Outdoor AP
Please enter "Device B" SSID in the "SSID" field for the WISP connection, and enter
"Device A" SSID in the "SSID of Extended Interface" field for the PC side connection.
In this mode,WLA-5200AP behaves virtually the same as in WISP mode, but
the AP can also send wireless signal to the Wireless LAN side.
The output-power is divided between 2 wireless sides, and proper antenna
installation can significantly improve the performance.
The AP is default to 802.11a mode, running in 5Ghz
spectrum. If you want to run it in 802.11b/g mode, you
need to change the settings. The AP can not run in both
802.11a and 802.11g mode simultaneously.
1.
2.
3.
4.
Downloaded from www.Manualslib.com
Select 802.11a, b, or g mode
Open your web browser and enter the AP's IP address.
Select Mode, and choose which wireless mode you want
for example, the default mode is AP mode and default band is 11a
(outdoor), you can click the setup button and choose the 11b,
11g,11a (indoor), or 11g+b mixed to change the 2.4Ghz or 5Ghz
band.
Click on Apply chnages to finish the setting
802.11 a/b/g Wireless AP
WLA-5200AP
manuals search engine
Device A:
Mode: WISP+Universal
English
9
9