Chapter 9: Faults And Repairs - vepa HomeFit Benutzerhandbuch

Chapter 9: Faults and repairs

It may happen that something occurs during use
causing the HomeFit
work anymore.
We strongly recommend that you do not
open components such as motors, con-
trols and displays yourself, but that you
consult trained and authorised mechanics.
If you press one of the arrows and the display
does not light up and the table moves up or
down, take the following steps:
Error code malfunction
none display does not light up
con Communication problem.
- - - Initialisation position.
F01 error in the initialisation.
F02 error in the initialisation.
F03 reading error.
F04 inconsistency.
F05 Gyrosense activated.
F06, F07 Height of power level activates stop on the
or F08 motor port.
F09 Maximum capacity of engine energy level
has been reached. (I2t) Overheating.
F10 Maximum capacity of controls energy level
has been reached. (I2t) Overheating.
F11 Maximum capacity of power supply energy
level has been reached. Overheating.
F12 Maximum temperature outgoing energy
engines has been reached.
F14 Maximum stroke of the spindles has been
reached.
F15 Motor is overloaded or blocked.
* Should this message occur when the table is in
its lowest or highest position and an initialisa-
tion is unsuccessful, it is best to contact your
reseller or the manufacturer.
An initialisation or reset is described in chapter 5:
Description of operation; method of use. (chapter
5.3 page 19).
24
home office desk to not
©
Check whether power is available. (try a
lamp, for example).
Check that all plugs are properly inserted
into the various contact points. By ad-
justing and possibly tightening of cables,
plugs can come loose.
If the power supply is OK, check the display for
error messages. The most common messages
and solutions are shown in the table below.
possible solution
No power available.
There is no connection between control box and display. Check
plug, possibly replace display.
Initialisation must take place.
Press any button on the display. If this does not work, discon-
nect the power supply for at least 20 seconds.
Press any button on the display. If this does not work, discon-
nect the power supply for at least 20 seconds.
Press any button on the display. If this does not work, discon-
nect the power supply for at least 20 seconds.
Press any button on the display. If this does not work, discon-
nect the power supply for at least 20 seconds.
Press any button on the display.
Reduce weight load of the table. *
Let the motor cool for at least 10 minutes.
Let the controls cool for at least 10 minutes.
Let the controls cool for at least 10 minutes.
Let the controls cool for at least 10 minutes.
Controls will automatically go into initialisation mode.
Reduce weight load of the table or unblock.
For malfunctions that do not appear on the list or
cannot be solved by yourself, please contact your
reseller or the manufacturer.
Any replacement parts can be purchased via
your reseller or the manufacturer.