Herunterladen Inhalt Inhalt Diese Seite drucken

Cisco ONS 15454 ML Bedienungsanleitung Seite 7

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

May 27 17:40:48.511: %CARDWARE-6-BTC_DRV: Init BTC, BTC Rev = 2,
Backplane = 0, Port = 0.
Die Portkonfiguration wird geändert, während Sie sie in ML anzeigen.
.225ML12#show ons provisioning-agent m ports all
----- Backend Port (00) Data -----
prov:
no
sts: xx
----- Backend Port (01) Data -----
prov:
no
sts: xx
Durch die Erstellung eines STS3c-Circuits werden die Port-Informationen zu ML aktualisiert. Die
Leitungsgröße wird auch in der Ausgabe des POS 0-Controllers angezeigt.
.225ML12#show ons provisioning-agent m ports all
----- Backend Port (00) Data -----
prov: yes
sts: 00
----- STS (00) Term Strip -----
Admin State: IS
Type: 3 Sf: 1E-4 Sd: 1E-7 C2 tx/exp: 0x01 / 0x01
PathTrace Format: 64Byte
expected: (not valid)
send: valid: "\000\000\000\000"
----- VT (255) Term Strip not provisioned -----
----- STS (00) Xc Strip -----
rate: 3
Admin: IS
Src
Port/STS: 0x09/0x00
Dest Port/STS: 0x06/0x00
Prev STS Stich Dest Port/STS: 0xFF/0x00
Next STS Stich Dest Port/STS: 0xFF/0x00
----- Backend Port (01) Data -----
prov:
no
sts: xx
Diese Protokolleinträge werden angezeigt:
May 27 17:47:08.711: %VIRTUAL_PA-6-PAPLUGGEDIN:
POS interface [0] has been created due to circuit creation
May 27 17:47:08.715: %CARDWARE-6-BTC_DRV: Init BTC, BTC Rev = 2,
Backplane = 0, Port = 0.
May 27 17:47:08.915: %LINK-3-UPDOWN:
Interface POS0, changed state to up
May 27 17:47:09.927: %LINEPROTO-5-UPDOWN:
Line protocol on Interface POS0, changed state to up
Loopbacks
Die Anwendung eines Anlagenschleifs auf den aktiven OC12-Port am .225 bewirkt, dass der .225
ML-Alarm TPTFAIL meldet. Dieser Alarm wird auch in den ML-Alarmlisten angezeigt.
Hinweis: Wenn Sie Loopbacks auf einem aktiven Pfad aktivieren, geht Datenverkehr verloren.
.225ML12#show ons alarm
Equipment Alarms
Active: None
Port Alarms
POS0
Active: TPTFAIL
POS1
Active: None
GigabitEthernet0
vt: xx
type: xxx
vt: xx
type: xxx
vt: 255
type: DOS
Direction: TX_RX_EQPT
Mode: OFF
STS Eqpt: 0x01
UPSR STS Cont Dest: 0x00
vt: xx
type: xxx
Active: None
name: xxxxx
name: xxxxx
name:
name: xxxxx

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis