LENCO IDP-3500 Schnellanleitung

English:
To complete below instruction correctely only use the controll buttons on the main unit.
Setting the clock:
Please make sure the unit is in standby mode. If the unit is turned on press
Setting time: Press and hold Time Set button. "12H" or "24H" will appear on the screen and begin to
flash.
12H / 24H: Use Time- or Time+ button to select 12-hour or 24-hour display. Press Time Set button to
confirm.
Hours: Press Time- or Time+ to adjust the hour, confirm by pressing Time set.
Minutes: Press Time- or Time+ to adjust the minutes, confirm by pressing Time set.
Setting the Alarm 1 & Alarm 2:
In following instruction we demonstrate Alarm 1 (The clock time needs to be set first before the alarm
can be used).
Please make sure the unit is in standby mode. If the unit is turned on press
Current settings: To view the set alarm 1 wake up time, press Alarm 1 button to display the set wake
up time and source.
Setting the Alarm: To set the alarm 1 wake up time, press and hold Alarm 1 button, the hour will start
to flash.
Press Time- or Time+ to adjust the hour, confirm by pressing Alarm 1.
Press Time- or Time+ to adjust the minutes.
Select the desired wake up source by pressing wake up until the desired wake up source is displayed,
confirm by pressing Alarm 1 button. Note: When no alarm is needed select no source and the alarm is
deactivated.
Wake up volume: Use + / - buttons to adjust the wake up volume. Note: Buzzer volume is fixed,
changes will only affect radio and iPod wake up volume.
Confirm the settings: Press Alarm 1 to confirm and activate the set wake up time, volume and
source.
Note: In order to wake to your iPod, make sure that your iPod is inserted into the dock correctly and
powered off. If the unit is in playback mode, no alarm will sound.
Using alarm function:
1. When the alarm sounds, press the SNOOZE button to temporarily deactivate the alarm. The
alarm will be activated again in approximate 8 minutes. This cycle repeats several times within 30
minutes.
2. To turn off the alarm for 24 hours (to wake up the next day at the same time), press and hold
button.
3. To prevent the alarm from coming on daily, enter the alarm setting mode and deactivate the alarm
by selecting no wake up source.
Please note that some buttons are push and hold (like
function.
Monteren van de aandrijfriem
QUICK-GUIDE Time & wake-up setting IPD-3500
to go in standby mode.
to go in standby mode.
button) to prevent undesired