Werbung
Set Up the Product
•
Wall and Flush Mount
•
Wiring
Type CR2032,
manufacturers: Fuji,
Maxell, Renata, Varta,
Panasonic, JHIH,
Power Glory Battery
Tech
-
Users shall not
replace the battery.
If the battery
needs replacing, a
factory trained
service professional
shall contact
Axis support a-
t www.axis.com/techsup f-
or assistance.
-
Used batteries shall
be disposed of
according to local
laws and regulations,
which may vary
from state to state.
Waste CR lithium
cells are neither
listed nor exempted
from the USEPA
hazardous waste
regulations. Waste
lithium batteries
can be considered
reactive hazardous
waste if there is a
significant amount
of unreacted, or
unconsumed lithium
remaining. For
information about
how to dispose
of used lithium
batteries, contact
your local authority
for waste disposal.
-
If using a flush mount
to mount the Axis
product, the flush
mount shall be UL
Listed.
-
Compliance with
IEEE 802.3 (at or af)
specifications has not
been verified as part
of UL 294/B.
-
Product is not
intended for outside
wiring as covered by
Article 800 in the
National Electrical
Code, NFPA 70.
•
System Considerations
•
Tampering
•
Firmware Version
•
Technical Specifications
-
The minimum
conductor gauge
to be used between
the PSE or power
injector and the PDE,
must be 26 AWG.
Maximum wire length
30 m (98.4 ft).
-
The conductor gauge
to be used for any
interconnecting wire
shall be no less than
22 AWG. Maximum
wire length 30 m
(98.4 ft).
-
All interconnecting
devices and wiring
must be Listed.
-
Category 5e cabling
is the minimum
performance category
recommended.
-
All wiring shall
be performed in
accordance with
NFPA70, local codes
and authorities
having jurisdiction.
-
The access control
system shall not
impair the intended
operation of the
panic hardware used
in conjunction with it.
-
To comply with
UL 294/38.1.3 (Elec-
trical Supervision),
the accelerometer
shall trigger an action
when the Axis prod-
uct is subjected to
tampering.
-
UL approved firmware
version: AXIS
A8105-E Network
Door Station –
1.XX.X.X
-
Verify UL approved
firmware version: Log
in to the product
web pages and go to
Setup > Basic Setup
or Setup > About to
verify that the stated
firmware version in
the Axis product is
the same as the UL
approved firmware
version.
Werbung
