Specifications - AddLife SVAN CARE Balance Installationsanleitung, Gebrauchsanweisung Und Überholung

No Part
16 Locking pin
17 Plastic ball
18 Threaded rod (included in Mounting Kit for Lavatory Seat, Item no 10 099)
19 Cone
20 Cone for stabilization
21 Nut
22 Footrest Substitute
23 Footrest
Before use: Be sure that Balance is well mounted and properly secured on the lavatory.
Clean the product with a mild detergent and water. If necessary, disinfect.
Disassemble the entire product. Clean the Lavatory Seat with a non-scratching detergent, rinse
with water and dry. Disinfect. Clean the other parts in the same way, alternatively with a dish
cabinet or similar equipment. Check all parts for wear and tear, replace if necessary.
Always protect parts against external stress during transport.
Balance is made of varnished stainless steel, with details in polyurethane without latex.
Lavatory Seat, Handles and Footrest can be turned in for incineration or recycling.
Metal parts are to be scrapped.
Balance can be combined with a number of products from Svan Care, e.g. Bidette, Hole Reducer
and Back Cushion, etc. These products are accompanied by separate instructions.
Important!
Balance may only be installed on lavatories
that are firmly anchored to floor or wall.
Never leave a person who is using
Balance unattended.
In case of any problems with Balance,
contact an occupational therapist or Svan Care
for support.
How To Use
Easy to Clean
Reconditioning
Transport and Storage
Material, Environment and Recycling

Specifications

Svan Care assumes no liability if this product
is used, changed or installed in any other way
than specified in this Installation and User
Manual.
Maximum load: Armrest 130 kg/pair,
Armrest Surround 130 kg/(50 kg)/pair,
Grab Rail 130 kg/pair,
Frame 130 kg, Footrest 60 kg.
21
Item number
10 008
10 009
Included in 10 099
Included in 10 099
Included in 10 099
Included in 10 099
10 038
10 039