Activating/Deactivating The Power Thresholds - Gewiss CHORUS GWA9801 Bedienungsanleitung, Programmierhandbuch

1. Current, expressed in amperes (8.3 A in the example)
2. Voltage, expressed in volts (240 V in the example)
3. Power factor (cosφ, 0.8 in the example)
4. Frequency, expressed in hertz (50 Hz in the example)
Use the and button keys to move between the various displays.
If you press the "SET" button key or after about 60 seconds of inactivity on the device, the absorbed
power screen is displayed.

Activating/deactivating the power thresholds

The number of the threshold is indicated at the top of the display, the activation ("On") or deactivation
("OFF") status at the bottom.
When the power threshold is exceeded, the
corresponding threshold; the symbol turns off when the power value drops below the threshold value
minus the set hysteresis.
The twenty different power thresholds (t1...t20) can be activated and deactivated locally.
To activate/deactivate one of the twenty power thresholds:
1. Go to the desired power threshold page
2. Press the "SET" button key
3. The threshold status ("on" or "off") starts flashing
4. Press the "SET" button key to switch from activation to deactivation status and vice versa
5. Wait for 3 seconds to confirm the selection
symbol is on constantly on the display page for the
pag. 15