Auto Search - SupportPlus URC-F17 Bedienungsanleitung

Downloaded from www.Manualslib.com
Remark:
1. To input the letters of the brand name, is just similar to input the words
like the mobile phone.
2. The keys of
remote. You can't control your device during the set up.
3. If the device is locked, you must first unlock the device then setting
up.
4. If not found brand or enter error, the screen will display "NOT FOUND"
2 seconds and over again enter.
5.You can press the EXIT key to clear the wrong letter when you enter
the brand name.
6.If you wait more than 30 seconds during set up or operation, the remote
control will be quited the current state.
B. Auto Search
If you failed in the direct set-up or you can not fi nd the brand name in the
screen that you want, you can use the "Auto Search" to fi nd the correct
code to operate your device.
1. Turn on the device (e.g. press the ON/OFF button on your television)
you would like to operate. If it is a VCR, Please insert a tape.
2. Press and hold the SET key for more than 3 seconds to start set up.
3. The screen shows "Code Setup?", and then press the "OK" key.
4. The screen shows "XX Auto Search?"(XX is a device name
and XX flash, you can press device (e.g. TV) key to select desired
device then press the "OK" key, the Auto Search begins and the
screen display "Searching?" and with code no. increasing (
point your remote control to the device that you want to control during Auto
).The remote control automatically send ON/OFF signal of
Search.
each code to the device (code scan)
5. See if device reacts or not, once the device reacts, press any key to
stop the search.
manuals search engine
OK, EXIT only are used to set-up your new
GB
You must
23