Aiwa LED-326HD Bedienungsanleitung Seite 5

8
en
DISASSEMBLY AND INSTALLATION
WALL-HANGING BRACKET
An optional wall mount can be used with
your television.
Consult with your local dealer to purchase
the recommended wall mount bracket.
Carefully attach the wall mount bracket
to the rear of the TV.
Install the wall mount bracket on a solid
wall perpendicular to the floor.
Please contact qualified personnel to
install the wall mount in any other place
other than a perpendicular wall.
Detailed instructions will be included
with the wall mount.
Please use a wall mount bracket that
adequately secures the apparatus to the
wall leaving enough space to connect
other external devices.
- Disconnect the power before moving
or installing the TV. Otherwise, electric
shock may occur.
- Remove the stand before installing the TV
on a wall mount.
- The TV may fall causing severe injury
if you install it on the ceiling or a
slanted wall. Use an authorized wall
mount and contact your local dealer
or qualified personnel or it won't be
covered by the warranty.
- Do not over tighten the screws as this
may cause damage to the TV and void
your warranty.
- To prevent injury, this apparatus must be
securely attached to the floor/wall
according to the installation instructions.
- Use screws and wall mounts following
these instructions.
Any damages or injuries caused due
to misuse or use of an unauthorized
accessories will not be covered by the
warranty.
Notes:
For TV sets with terminals towards the
1.
wall, in order to leave enough space to
use the terminals, a rubber cushion is
needed with each screw to fix the wall
mount.
lt's a small hollow pillar with an 8mm
internal diameter, 18mm external diameter
and _ > 30mm height.
2. The information in this document is
subject to change without notice. The
manufacturer accepts no liability for
damage resulting directly or indirectly
from faults, incompleteness or discrepancies
between user manual and the product
described.
3. In a dry environment due to static
electricity, the product may restart and
return to the main OSD interface, USB
player interface or the previous source
mode. lt's normal and please continue to
operate the TV as you normally would.
DESCRIPTION OF THE TELEVISION
FRONT VIEW
BOTTOM VIEW
LED DISPLAY SCREEN
IR REMOTE CONTROL SENSOR &
POWER INDICATOR
In standby mode the indicator light
is red; when switching on the TV the
indicator light turns blue.
STAND HOLDERS
CH+ / CH- (CHANNEL +/-)
Press forward to select the next channel or
backward to select the previous channel.
MULTIFUNCTION & POWER BUTTON
During standby, press to turn on the TV.
When TV is on, short press to access
the source list, and short press again to
access to the selected source.
When the TV is on, long press to turn
it off.
VOL+ / VOL- (VOLUME +/-)
Press left to increase volume or right to
decrease the volume level.
9