Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General
1. Overview Components
Glass bottom
2. General Information
•
The post curing unit is intended for curing
components manufactured in the DLP process.
•
When equipping the unit, ensure that
XXX- the components are clean and dry.
XXX- the components should not be stacked or
XXX-
overlap each other.
XXX- the components should not cast shadows
XXX-
over each other.
XXX- the maximum component height of 60 mm
XXX-
should not be exceeded.
•
For proper curing of the components, observe
the specifications of the material manufacturers.
•
For proper operation of the post curing unit,
keep the exposure chamber clean and dust-free.
(See the cleaning instructions on page 3.)
1
Back plate
Operating instructions
•
For safety reasons, the unit should not be
opened during curing process.
•
In case the curing result deviates from the
desired result, cure again or contact Customer
Services.
•
Read the full operating instructions for safe work
and best results with the post curing unit.
Werbung
