Talon Pro TD7910 Benutzerhandbuch Seite 9

Read the user manual before using the machine
Waste electrical products must not be disposed of
with household waste. This tool should be taken to
your recycling centre for safe treatment.
IMPORTANT SAFETY INSTRUCTIONS FOR
CHARGER
Save These Instructions
Input: Only use the rated voltage marked in charg-
er.
1. Charging voltage: 18V
Quick charge current :4.0 Amp Lithium
3.0 Amp Ni-cd
3.0 Amp Ni-MH
Maintaining charge : 200 mA
Battery charging time at 20˚C
Ni-Cd . . . . . . . . . . .30Min
Ni-MH . . . . . . . . . .1hr
Lithium . . . . . . . . . .1hr
NOTE:The charging time may vary according
to an ambient temperature and power source
voltage.
2. Before charging, study the instruction sheet;
3. Disconnect the supply before making or break-
ing connections to the battery;
4. For indoor use or do not expose to rain (for
ordinary battery chargers).
5. Correct use: Universal fast chargers are to be
used exclusively for charging 18V TALON
serious rechargeable battery packs. Any other
may result in risk of fire, electric shock or elec-
trocution.
The user bears sole responsibility for any dam-
age caused by inappropriate use.
The generally recognized accident prevention
regulations and the safety instructions which
accompany them must be adhered to.
• Use only C186 chargers for charging System
B186 & B187 Serious packs. Do not use bat-
tery packs from other systems.
The following battery packs can be charged
with this charger
Voltage battery rating No. of battery
(of storage battery) cells
18V B186 1.3 Ah
18V B186 2.5 Ah
18V B186 3.0 Ah
18V B187 3.0 Ah
Downloaded from www.Manualslib.com
Double Insulated
DANGER: High voltage present at
charging terminals. Do not probe with
conductive objects. Danger of electric
shock or electrocution.
DANGER:
Cracked
pack case is cracked or
damaged, do not insert
into charger. Danger of
electric shock or electro-
cution.
B186 B187
• UNIVERSAL CHARGER
Before
Red LED steady on
charging
Red LED blinking slowly
While
charging Green light steady on
Charging
Green light blinking
complete
Malfunction Red and Green light blink
battery sequenially
If the supply cord is damaged, it
must be replaced by the manu-
facturer or its service agent or a
similar qualified person in order
to avoid a hazard.
SAFETY PRECAUTIONS WHEN USING
CHARGER AND BATTERY
1. Do not charge battery when temperature is
below 41˚F (5˚C) or above 113˚F (45˚C). The
most suitable temperature for charging is that
of 20~25˚C.
2. Never attempt to connect two chargers together.
3. The charger is designed to operate on stan-
dard household electrical power. Do not
attempt to use it on any other voltage.
4. Do not insert foreign matter into the hole
reserved for the battery in charger stand.
5. Do not charge by means of an engine genera-
tor or DC power source.
6. Do not disassemble the battery and charger,
by yourself incorrect reassembly may result in
a risk of electric shock, electrocution or fire. Let
Ni-Cd
the battery and charger by repaired by profes-
Ni-MH
sional engineer.
Lithium
7. Do not store the tool and battery in locations
Lithium
where the temperature may reach or exceed
113˚F (45˚C), such as outside sheds or metal
buildings in summer.
1
manuals search engine
GB
8. Do not incinerate the battery, even if it is
severely damaged or completely worn out.
The battery may explode in fire.
9. Battery leakage may occur under conditions of
extreme usage or temperature. If liquid comes
in contact with skin, wash quickly with soap
and water, then lemon juice or vinegar. If liq-
uid gets in your eyes, wash with a strong solu-
tion of boric acid and seek medical attention
immediately.
If battery
10. Never short-circuit the rechargeable battery.
Shortcircuiting the battery will cause a great
electric current and over heat. It results in burn
or damage to the battery.
11. Charge battery pack only with the charger
provided.
12. The battery pack for this tool has been shipped
in a low charge condition, therefore, you
should charge it prior to use.
13. Do not insert foreign object into the air
ventilation slots of the charger.
Stand by
Inserting metal objects or inflammable into the
Battery too cold
charger air ventilation slots will result in electri-
Charging
cal shock hazard or damaged charger.
14. This appliance is not intended for use by per
Full charged
sons (including children) with reduced physi-
Replace the
cal, sensory or mental capabilities, or lack of
battery
experience and knowledge, unless they have
been given supervision or instruction concern-
ing use of the appliance by a person responsi-
ble for their safety.
15. Children should be supervised to ensure that
they do not play with the appliance.
16. Do not dispose of electrical appliances as
unsorted municipal waste, use separate col-
lection facilities.
17. Contact your local government for information
regarding the collection systems available.
18. If electrical appliances are disposed of in land-
fills or dumps, hazardous substances can leak
into the groundwater and get into the food
chain, damaging your health and well-being.
19. When replacing old appliances with new once,
the retailer is legally obligated to take back
your old appliance for disposal at least for free
of charge.
20. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similar qualified person in order to
avoid a hazard.
WARNING: If any parts are missing, do
not operate tool until the missing parts
are replaced. Failure to do so could
result in possible serious personal
injury.
WARNING: Do not recharg non-
rechargeable batteries
DISPOSAL OF THE EXHAUSTED BATTERY
WARNING: Do not try to charge non-
chargeable batteries with this charger.
For safety and to preserve natural resources,
please recycle or dispose of properly. This Product
Contains Nickel-Cadmium Battery.
Must Be Disposed Of Properly. Local, state, or fed-
eral laws may prohibit disposal of NIckel-Cadmium
batteries in ordinary trash. Consult your local
waste authority for information regarding available
recycling and/or disposal options.
B ATTERY PACK PREPARATION FOR RECYCLING
WARNING: Upon removal, cover the
battery pack's terminals with heavy
duty adhesive tape. Do not attempt to
destroy or disassemble the battery
pack or remove any of its components.
Do not touch both terminals with metal
objects and body parts, as short-circuit
may result. Keep away from children.
Failure to comply with these warnings
could result in fire and/or serious injury.
2
GB