Ai Edit Recording - Aiwa NSX-SZ10 Bedienungsanleitung

AI EDIT RECORDING

The AI edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(AI: Artificial Intelligence)
1 Insert the tape into deck 1, and wind up to the
beginning of the front side.
Press Z to open the cassette holder and insert the tape
with the side to be recorded on first facing out from the unit.
Wind up the tape with f.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK once while pressing
SHIFT on the remote control.
"EDIT" and "AI" are displayed.
• When "PRGM" is displayed, press CD EDIT/CHECK while
pressing SHIFT again.
4 Press DISC DIRECT PLAY 1-3 to select a disc.
5 Press numbered buttons 0-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and 0.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
• f and g are also available to designate the tape length.
Tape length
Downloaded from www.Manualslib.com
Remaining Programmed
time of recording tracks for side A
Minus mark
Tape side
A: First recording side
B: Second recording side
manuals search engine
6 Press w on deck 1 to start recording on the first
side.
CD play and recording of edited tracks for the first side start
simultaneously. When the end of the tape is reached, deck 1
enters the recording stop mode. After entering the recording
stop mode, go to step 7.
7 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to display the program for the
second recording.
"B" is displayed.
8 Turn over the tape in deck 1 and press w to start
recording on the second side.
To stop recording
Press s /z on deck 1. Recording and CD play stop
simultaneously.
To clear the edit program
Press s CLEAR twice so that "EDIT" disappears on the display.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press f or
g repeatedly.
Track number
Tape side Program number
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment .
1 Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press numbered buttons on the remote control to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
The AI edit recording function cannot be used with discs
containing 31 tracks or more. "TR OVER" is displayed if this is
attempted.
Programmed track numbers
En
13
ENGLISH