Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Set up
Button "sensor" ( left): You can also adjust the item's sensitivity
and range. By turning the knob clockwise you increase the
range of protection.
Button "frequency" (right): This is to control frequency. By
turning the knob clockwise, the frequency will be increased.
Button "frequency" positions as below:
off
0:
1:
13.5KHZ - 19.5KHZ
To repeal animals such as mice, rats,
dogs, foxes and martens.
2:
19.5KHZ - 24.5KHZ
To repeal animals such as cats,
raccoons, badgers and skunks.
3:
24.5KHZ - 45.5KHZ
To repeal animals such as bats,
birds, pigeons and rodents.
Strong flashing lights to repeal
4:
animals such as raccoons, boars
and martens.
5:
All functions working, sweep
frequency from mode 1, mode 2,
mode 3, and turn on strong flashing.
4
To Assemble and Install
Remove the battery compartment on the back; install 3x
1.
AA size rechargeable batteries, and then close the battery
compartment. (batteries included)
2.
Place the unit pointed towards the area you want to
protect (for example, in the flowerbed or against the wall
etc.)
figure 1
3.
Remember to choose a place where the solar panel can
catch sunlight as long as possible.
4.
If you mount the unit in the ground, insert the spike into
the ground carefully (see figure 1 to connect the pole
sections). Please leave the spike 12 cm or more above the
ground (see figure 2.) It is suggested you dig a hole and
then examine the units to ensure no damage occurs.
5.
The item can be inserted in the ground, or mounted
against the wall, or the top part can be put directly on a
flat surface.
figure 2
Battery issue warning
1.
If new rechargeable batteries or battery in the products
aren't used for more than 1 month, the batteries power
above the
must be fully released. It is suggested to charge the
ground
batteries 3 or 5 times to activate before regular use.
line
2.
When rainy or cloudy weather lasts for up to one week,
the item may stop working. We suggest you turn off the
ENGLISH
5
Werbung
