Herunterladen Inhalt Inhalt Diese Seite drucken

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Limited One Year Warranty
T&S warrants to the original purchaser (other than
for purposes of resale) that such product is free from
defects in material and workmanship for a period of
one (1) year from the date of purchase. During this
one-year warranty period, if the product is found to
be defective, T&S shall, at its options, repair and/
or replace it. To obtain warranty service, products
must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transpor-
tation charges of the product to T&S and the return
of repaired or replaced product to the purchaser are
the responsibility of the purchaser. Repair and/or
replacement shall be made within a reasonable time
after receipt by T&S of the returned product. This
warranty does not cover Items which have received
secondary finishing or have been altered or modi-
fied after purchase, or for defects caused by physi-
cal abuse to or misuse of the product, or shipment
of the products.
Any express warranty not provided herein, and
any remedy for Breach of Contract which might arise,
is hereby excluded and disclaimed. Any implied
warranties of merchantability or fitness for a particu-
lar purpose are limited to one year in duration. Under
no circumstances shall T&S be liable for loss of
use or any special consequential costs, expenses
or damages.
Some states do not allow limitations on how long
and implied warranty lasts or the exclusion or limi-
tation of incidental or consequential damages, so
the above limitations or exclusions may not apply
to you. Specific rights under this warranty and other
rights vary from state to state.
P/N: 098-006105-45 Rev.1
Date: 980324
Drawn: CW
Checked: JLT
4-14-98
Approved: MW 4-14-98
Installation and
Maintenance
Instructions
KETTLE & POT FILLER
B-0600 Series
(Also for B-0601, B-0605, B-0606,
B-0610 and B-0611)
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für T&S B-0600 Serie

  • Seite 1 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/ or replace it.
  • Seite 2: Exploded View

    Exploded View...
  • Seite 3 Part Number Guide Vacuum Breaker & Faucet Assemblies Asm, Body Faucet B-0600 & B-0601 000101-40 & 000181-40 Asm, Body Faucet B-0605 & B-0606 B-0310-LN Asm, Body Faucet B-0610 & B-0611 B-0330-LN Adapter 3/8 MA x ¾-14 MA 000545-25 Elbow, 3/8 001355-40 Asm, 3/8 Vacuum Breaker Nut, Swivel Adapter...
  • Seite 4: General Instructions

    General Instructions Installation: B-0600 Other units will be similar, except where noted. 1. Shut off water supply and drain lines. Existing supply lines should be roughed into wall or sink decking. Use ½” NPT inlets. 2. Install no.1 to supply line, using teflon tape. Flange of no.1 should screw in toward body.
  • Seite 5: Instrucciones Generales

    Instrucciones Generales Instalación: B-0600 Otras unidades serán similares, excepto donde está indicado 1. Cierre la fuente principal de agua y desagüe las tuberias. Las lineas existentes de surtido, deben de ser aproximadas en la pared ó en el armario de la sentina, use entradas de 1/2"...
  • Seite 6: Instructions Générales

    Instructions Générales L’Installation: B-0600 Les autres éléments aller être semblable, sauf où noter. 1. Fermer la réserve de l’eau et égoutter la tuyauterie. La tuyauterie qui fournir l’eau qui exister devoir être installer dans le mur ou le comptoir de l’évier. Utiliser les inlets 1”...
  • Seite 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Installation: B-0600 Die anderen Einheiten sind ähnlich, sofern nichts anderes angegeben 1. Wasserzufuhr sperren und Wasserleitungen entleeren. Bestehende Wasserleitungen sind in die Wand oder die Abdeckplatte für das Waschbecken einzuführen. 1,27 cm NPT-Einlaßventile verwenden. (NPT = Nation Pipe Taper) 2.
  • Seite 8 RELATED T&S BRASS PRODUCT LINE B-0592 Pot and Kettle Filling Faucet B-0597 Pot and Kettle Filling Faucet T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’...

Diese Anleitung auch für:

B-0601B-0605B-0606B-0610B-0611Brass b-2312 ... Alle anzeigen

Inhaltsverzeichnis