Power Supply And Charging; Power On / Power Off - BeeWi BBX200 Bedienungsanleitung

7

1.6. Power Supply and Charging

- The battery must be charged with the cable provided. Unplug the audio
jack and connect the power cable directly to the Transceiver. When the
power is on, the Transceiver will automatically power down and it needs
to be turned on again. You can use the Transceiver when it is charging by
plugging the audio cord into the power cable audio jack.
- The red LED indicator will stay on while charging and will be off as
soon as it is completed. It takes approximately 2.5 hours to re-charge
every time.
Warning: fully charge the device at least 3 hours before first time use!
2. USING THE PRODUCT AS A RECEIVER

2.1. Power On / Power Off

- make sure the rotation switch is in RX position.
- Power On: Press and hold the key
until blue indication start blinking.
- Power Off: long press the key for 5 seconds until the
red and blue LED indicators light on and off.
2.2. RX Pairing
You can pair up to 8 devices to the BBX200 Transceiver.
- Refer to the Bluetooth pairing procedures in corresponding mobile phone
or music player user manual.
- make sure the BBX200 is power off and the rotation switch is in Rx
position.
- Long press the key for 8 seconds when device is off until the blue
indicator blinks rapidly, then release the key. At this moment, the product
is in the pairing mode.
- Select the device name "BeeWi BBX200" on the screen of the phone and
enter the pass key - 0000 - to add this device into your phone device list.
- Select "connect" to connect the "BeeWi BBX200" and the phone.
- Check the connection by placing a call or playing the music from your
phone.
- To pair a second device, turn off the Transceiver and repeat the procedure
above.
ENGLISH
Downloaded from www.Manualslib.com manuals search engine