Speaker Connections - NXS NX200.2 Installationsanleitung

Make the speaker connections using speaker wire that is at least 16 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential
for strong bass response. When connecting, make sure that positive (+) from the
amplifier is connected to the positive (+) of the speaker, and the same for negative (-).
Please note that although the NX1000.1 is a mono amplifier, we have provided two sets
of speaker terminals on the amplifier. These terminals are connected in parallel
internally (connected together). The second set of speaker terminals are intended for
ease of connection when running multiple woofers.
HIGH
PRIMARY AMP MULTI-AMP LEVEL INPUT
LEVEL
REMOTE ADDRESS ADDRESS CONTROL
LEVEL
AUTO SENSING
FUSE
ON
OFF
8 4 2 1 A SW
ON OFF
MIN MAX
DSP NETLINK
100A
IN OUT
- -
- -
Dual 4 Ohm Woofer
NX1000.1 CONNECTIONS
INPUT
L
R
NX200.2 & NX400.2 CONNECTIONS
Downloaded from www.Manualslib.com
S
PEAKER CONNECTIONS
INPUT POWER BRIDGE SPEAKER
L IN
MODE
MASTER SLAVE
PRT PWR
NX1000.1
R OUT
- -
+ +
- -
+ +
(*1 Ohm Load)
Dual 4 Ohm Woofer
HIGH LEVEL INPUT
INPUT CH1
LEVEL
MIN MAX
CH1&2 CH3&4
NX400.4
CH2
NX400.4 CONNECTIONS
OUTPUT HIGH SPEAKERS
PRIMARY AMP MULTI-AMP LEVEL
LEVEL
REMOTE ADDRESS ADDRESS CONTROL
L R
AUTO SENSING
ON
PWR
L
ON OFF OFF
8 4 2 1 A SW
DSP NETLINK
PRT
R
NX200.2
IN OUT
BRIDGED
+ + - - + +
4 Ohm Speaker 4 Ohm Speaker 4 Ohm Speaker 4 Ohm Speaker
(2 Ohm Minimum) (2 Ohm Minimum) (2 Ohm Minimum) (2 Ohm Minimum)
manuals search engine
IMPORTANT! The speaker connections
shown for the NX1000.1 is a normal mono
configuration. If you are using more than
one NX1000.1 in a Power Bridge
configuration, please see speaker
connections in the Power Bridge section of
this manual.
**CAUTION! The NX1000.1 must see a 1 Ohm
+ +
load or higher. Any lower than 1 Ohm will cause
+ +
the amplifier to overheat and possibly cause
permanent damage to the amplifier!
OUTPUT SPEAKERS
PRIMARY AMP MULTI-AMP LEVEL REMOTE
CH3 L
ADDRESS ADDRESS CONTROL CH1 CH2
AUTO SENSING
ON
OFF ON OFF
8 4 2 1 A 1/2 3/4
DSP NETLINK
CH4 R
BRIDGED
IN OUT
4 Ohm Speaker 4 Ohm Speaker
(2 Ohm Minimum) (2 Ohm Minimum)
POWER
FUSE +12V REM GND
25A
4 Ohm Speaker 4 Ohm Speaker
(2 Ohm Minimum) (2 Ohm Minimum)
- -
11
POWER
+12V REM
CH3 CH4
FUSE
PWR
PRT
60A
BRIDGED
+ + - - + + - -
4 Ohm Speaker 4 Ohm Speaker
(2 Ohm Minimum) (2 Ohm Minimum)
+ + - - + + - -
4 Ohm Speaker 4 Ohm Speaker
(2 Ohm Minimum) (2 Ohm Minimum)
GND