Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
OPERATION
INSTRUCTIONS
Left side
1
OPERATION INSTRUCTIONS
1.) BATTERY CASE
Remove at first the cover of the battery case, by pulling the cover cautious downward away.
Then deposit two appropriate AAA 1.5 Volt Batteries (not included in delivery) into the battery case.
Please ensure the correct polarity of the batteries, like described in the inside of the battery case.
2.) POWER ON/OFF SWITCH
Turn on the headphones, by switching to ON position. After the use, switch back to OFF position.
3.) OPERATION LED
If the OPERATION LED lights up in red, the headphones are in operation mode and ready to use. If no sufficient input infrared
signal will be received or the input signal is somehow to weak or disturbed, the headphones switch to AUTOMUTE-Mode, until
a proper input signal is received.
GENERAL INSTRUCTIONS
• The ESX VM1HP Headphones work only under proper conditions by using the LCD ESX VM702C as transmitter.
The proper operation together with devices from other suppliers is not guaranteed.
• The effective range between the transmitter (VM702C) and receiver (VM1HP headphones) must be below 8 meters. The
quality of the input signal will be reduced by a wider range.
• Bright sunlight and other strong light sources could affected the transmission of the infrared-signal.
• Please avoid using the headphones outdoor and protect them against wind, moisture and bright sunlight.
• WARNING: Never use the headphones as driver while you drive your vehicle!
The use of the headphones with very high volume could damage your ability to hear enduring!
Downloaded from
www.Manualslib.com
VM1HP WIRELESS IR-HEADPHONE
Audio Design GmbH
Am Breilingsweg 3 · D-76709 Kronau / Germany
Fon +49(0)7253 - 9465-0 · Fax +49(0)7253 - 946510
www.audiodesign.de
manuals search engine
Right side
2
4
3
Werbung
