Hema 80.01.0055 Gebrauchsanleitung Seite 20

3. Rear grille assembly
Unscrew the blade fastening screw and the guard fastening screw from the motor shaft.

Fix the rear guard onto the two pillars of the motor front shell.

Screw the guard fastening screw tightly in clockwise direction.

4. The assembly of fan blade
Insert fan blade onto shaft ensuring blade fits properly onto clip on shaft.

Tighten blade screw onto shaft. Note: Blade screw should be tightened in anti-clockwise.

5. Front grille assembly
Put the front guard against the rear guard and fix with the clamping ring. Make sure the clamping ring is set

properly at the rim of the fan guards.
Tighten the screw on the clamping ring.

OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: To make the fan head oscillate, push down the oscillation knob. To stop the fan head from
oscillating, pull up the oscillation knob.
3. The fan is switched on by using the push buttons on the control panel, i.e. 0: Off, 1 = Low Speed, 2 = Medium
speed, 3 = High speed.
CAUTION: Press only one of the speed control button at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
RECYCLING
This product bears the selective sorting symbol for waste electrical and electronic equipment
(WEEE).
This means that this product must be handled pursuant to European Directive 2012/19/EU in
order to be recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment
and human heath due to the presence of hazardous substances.
QUALITY
Safety and quality is very important to HEMA. We have our own laboratory, which assesses all equipment in
terms of electrical safety and ease of use, before it is included in our range. HEMA also monitors the product
quality in collaboration with the manufacturer.
SECURITY
This HEMA item may be fitted with a plastic anti-theft strip. You will find the strip on the bottom of the product.
This strip does not influence the quality or the operation of the product and can be removed without a problem.
- 19 - 80.01.0055