Cisco Small Business 200 Serie Kurzanleitung Seite 4

2
To connect the smart switch to the network:
S 1
TEP
S 2
TEP
S 3
TEP
Cisco recommends using Cat5 or better cable for Gigabit
N
OTE
connectivity. When you connect your network devices, do not exceed
the maximum cabling distance of 328 feet (100 meters). It can take up to
one minute for attached devices or the LAN to be operational after they
are connected. This is normal behavior.
Power over Ethernet Considerations
If your switch is one of the Power over Ethernet (PoE) models, consider the
following power requirement:
• As a Power Sourcing Equipment (PSE) device, the switch can deliver a
maximum of 15.4 Watts per PoE port to a Powered Device (PD).
• The total power budget available for all devices is 32 Watts.
• Ports 1-4 are PoE ports, 5-8 are standard Ethernet ports.
W
ARNING
4
Downloaded from www.Manualslib.com
Connecting Network Devices
Connect the Ethernet cable to the Ethernet port of a computer,
printer, network storage, or other network device.
Connect the other end of the Ethernet cable to one of the
numbered smart switch Ethernet ports.
The LED of the port lights if the device connected is active. Refer to
Features of the Cisco Small Business Smart Switch, page 8
details about the different ports and LEDs on each switch.
Repeat Step 1 and
the smart switch.
The switch should be connected only to PoE networks without
routing to the outside plant
manuals search engine
Step 2 for each device you want to connect to
200 Series 8-Port Smart Switches
for