HomeMatic HM-RC-4-3 Bedienungsanleitung Seite 60

Resetting to the as-delivered condition
To cancel the reset process, press the teach-in
button again briefly or wait for 20 seconds. In
both cases, the slow red flashing and the reset
process will stop.
• To reset the wireless remote control, now press
and hold the teach-in button for at least another 5
seconds. With the button held down, the LED will
now start to flash red faster.
• When you release the teach-in button, this will
complete the reset process.
• The red LED will stop flashing and the wireless
remote control will perform a restart.
• Following the LED test display (red, green, orange
flashing - see Section 6.1.3 „Behaviour after repla-
cing batteries"), the wireless remote control will be
reset and ready for operation.
Possible error messages:
The errors listed below can only occur if you
have taught the wireless remote control in to a
central control unit.
If the LED does not start to flash once the button has
been held down for 5 seconds but lights up continuo-
usly instead, this means the wireless remote control
60