Herunterladen Diese Seite drucken

Conrad 10dBi Bedienungsanleitung Seite 2

Wlan-antenne

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

O P E R A T I N G I N S T R U C T I O N S
WLAN Antenna 10dBi
Item-No. 97 21 57
Intended Use
This product is intended as an antenna for appropriate WLAN cards, WLAN routers or similar.
This product complies with the applicable National and European specifications. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Included in the package
• WLAN Antenna
• Foot
• Operating Instructions
Features
• Both standing and wall mounting possible
• Indoor operation
• Gain 10dBi
Safety Instructions
The warranty will be void in the event of damage caused by failure to obser-
ve these safety instructions! We do not assume any liability for any
consequential damage!
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions. The warranty
will be void in such cases.
The unauthorized conversion and/or modification of the product is not allowed
because of safety reasons.
The product is intended for use in dry indoor locations, it must not get damp or wet!
The product is not a toy and should be kept out of the reach of children. Therefore,
be especially careful when children are around.
Do not carelessly leave the packaging material lying around since it could become
a dangerous plaything for children.
Handle the product carefully, it can be damaged by impacts, blows or by falling from
a low height.
Standing or Wall Mounting
The foot, included in the delivery, can be used as base and also as a wall fixture.
Please keep in mind that the tip of the WLAN antenna must always point straight upwards.
Pay attention, when tightening the screws during mounting the product to a wall, that no power,
gas or water pipes are damaged.
Connection
www.conrad.com
First, switch off the device on which you want to replace the WLAN antenna (e.g. switch off the
computer with WLAN card or the WLAN router).
Version 05/09
Remove the existing WLAN antenna.
Connect the delivered WLAN antenna to the terminal on your WLAN card, WLAN router etc.
Switch on the device again (e.g. computer or WLAN router).
The vertical range is 360°, the horizontal range is 30°, see figure above. Adjust the antenna as
needed, if applicable.
Disposal
Technical Data
Antenna type ................................................Omnidirectional
Frequency range ..........................................2.4 - 2.4835 GHz
Network type ................................................802.11b, g, n
Gain..............................................................10dBi
Horizontal range ..........................................30°
Vertical range ..............................................360°
Polarisation ..................................................Vertical (linear)
Impedance....................................................50 Ohms
Connection ..................................................SMA
Cable ............................................................RG178, length ca. 100 cm
Operating temperature ................................-20°C to +70°C
Storage temperature ....................................-30°C to +85°C
Air humidity ..................................................max. 95% relative, non-condensing
© Copyright 2009 by Conrad Electronic SE.
Please dispose of the device when it is no longer of use, according to the current
statutory requirements.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.

Werbung

loading