Before First Use; Dry Ironing; Steam Ironing - Umuzi Cleaning UZ-CL-STIS01 Bedienungsanleitung

X O X
Before first use
Make sure the water tank (1) is filled with cold water.
Turn the temperature dial (D) to the maximum temperature (IV) and allow the device to heat up.
Once the temperature indicator (B) switches off, hold the steam trigger (C) and iron over a piece of damp
cloth, for several minutes. This to ensure that possible residue in the device and soleplate is removed.
Note! It is normal that a strange odor is released from the device when used for the first time. This will
cease after a short while.
Note! Some particles may come out of the soleplate when the device is used for the first time. These
particles are harmless and stop coming out after a short while.
Ironing
The device can be used for 2 ironing methods; dry ironing & steam ironing.

Dry ironing

Place the device on a flat and stable surface, on a location where it cannot fall over.
Put the iron correctly on the thermal isolation (5).
Connect the power plug to an earthed electrical outlet.
Turn the temperature dial (D) to the desired temperature, corresponding with the fabric to be ironed.
When the temperature indicator (B) switches off, the device is at the set temperature and you can start
ironing.
During use, the temperature indicator (B) will light up again, indicating it is heating in order to maintain
the set desired temperature.

Steam ironing

Place the device on a flat and stable surface, on a location where it cannot fall over.
Make sure the water tank (1) is filled with cold water.
Put the iron correctly on the thermal isolation (5).
Connect the power plug to an earthed electrical outlet.
Turn the temperature dial (D) to the desired temperature, depending on the fabric to be ironed.
When the temperature indicator (B) switches off, the device is at the set temperature.
When pulling and holding the steam trigger button (C), steam will emit, and you can start ironing with
steam.
EN-7