Denon Professional DN-202WT Benutzerhandbuch Seite 4

4. Status Light: This LED indicates the DN-202WT's pairing status:
•
Flashing slowly (approximately once per second): DN-202WT is
not paired to a DN-202WR.
•
Flashing quickly (approximately twice per second): DN-202WT is
"searching" for a DN-202WR.
•
Solidly lit: DN-202WT is paired to a DN-202WR.
5. Stereo/Mono Selector (St./Mono): Press this button to set the
outgoing wireless audio signal to stereo (raised position) or mono
(depressed position).
Note: For stereo operation, make sure the left (L) and right (R) inputs
are connected to left and right outputs, respectively.
6. Peak Lights: These LEDs light up when the incoming audio signal is
"clipping" (distorting) at levels higher than 0 dB. If this happens,
reduce the volume level of your audio source.
7. Inputs (Balanced XLR): Use XLR cables to connect these inputs to
your audio source (mixer, media player, etc.). See
information.
8. Inputs (Unbalanced 1/4" / 6.35mm): Use 1/4" (6.35 mm) cables to
connect these inputs to your audio source (mixer, media player, etc.).
See Setup
4
for more information.
Setup for more