Operation - Ratio Electric MOBI BOX Bedienungsanleitung

OPERATION

The Ratio Electric Mode 2 Charge Cable offers maximum security when charging
your EV from a standard Schuko or CEE outlet.
Just plug the wall plug into the earth-grounded 230V wall socket.
Always plug in the wall socket first.
Now the Power LED will light up. The 6A Ready/Charge LED will start blinking.
You can change the charge current by pressing the button. The chosen charge
current LED starts blinking.
Plug the vehicle connector firmly into the vehicle's charge port. After a few
seconds Ready/Charge LED stops blinking and will be lighting continuously. Now
the cable is charging at the selected current.
During the charging it's not possible to change the charge current anymore.
When disconnecting the charge cable, always remove the vehicle connector first
then remove the plug from the wall socket.
For charge cables with a Schuko wall plug you can choose between
Note:
6A, 10A and 13A.
For charge cables with a CEE wall plug you can choose between
6A, 10A and 16A.
ERROR NOTIFICATION
In case of earth failure, the Fault LED lights up red immediately after the wall plug
is plugged into the wall socket. To avoid the error the wall socket needs always to
be earth grounded.
The Fault LED can also light up red during the charging.
In this case please remove the vehicle connector from the vehicle and wait a few
seconds. Choose the charge current and plug the vehicle connector once more
into the charge port of the car.
If the Fault LED lights up again remove the vehicle connector and the wall plug.
If the Mobi Box continues to display the error during the charging, please contact
Ratio Electric for support.
ENGLISH 15
ENGLISH 15
MOBI BOX / EV030
MOBI BOX / EV030