Intec Max Tools AirMan PAC10 Bedienungsanleitung Seite 10

English
OPERATION INSTRUCTION
Connect to the power source
The PAC10 can be power by Li-ion battery pack and serves as cordless handheld inflator. OR
power by 12V car plug cable by connecting the cable to the vehicle power outlet.
Choose proper adaptor for your inflation task
The PAC10 package comes with different adaptors for different inflation tasks. You can attach
the adaptor direct to the Air Outlet Nozzle of the compressor or connect with the Air Hose if
needed.
Set the desired pressure and pump air
Always reset the pressure before operating. Check the manufacturer's manual for the
recommended air pressure level of the object you want to inflate. Follow below steps:
1. Activate LCD display by pressing On/Rest button. The LED light will lit up at the same
time.
2. Select unit by pressing the On / Reset button.
3. Adjust pressure levels by pressing the Up / Down button. When you stop pushing the
button, the digit on display will flash 3 times to indicate a pressure level has been set.
Then the display will back to 0 and it is ready to inflate.
4. Press the trigger to inflate. Press the trigger again to stop or the compressor will
automatically stopped when the pressure reached the preset pressure. Always press the
trigger again to switch off the device properly after the device auto-stopped.
5. The LCD display will come off when the device is idle for 30 seconds. Press the On/
Reset button again if you want to restart.
10