Safety Instructions; Installation; Operation - LTC POWER LF10R Bedienungsanleitung

1. Safety Instructions

•
Please keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives
this instruction booklet.
•
Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
•
The unit is for in- and outdoor use. However don't immerge it into water.
•
Disconnect mains power before fuse replacement or servicing.
•
In the event of serious operating problem, stop using the unit immediately.
•
Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center and always use the same type of spare parts.
• Do not touch any wires during operation as high voltage might be causing electric shock.
• The light source of this product is a non-replaceable led.
• Do not disassemble the product, as the light waterproof function will be impaired.
• Don't direct the light beam directly to a person to avoid harming eyes.
• Don't connect the unit directly to the mains in order not to burn out the electrical circuit.
• Recharge the battery on time. Low battery power for a longer period of time can affect battery life when not in use.
•
Leave at the battery always charged at around 60% to lengthen its life time.
•
Put the cover of the charging socket back in place after having completed the charge in order to keep the product
waterproof and prevent water from penetrating the housing.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
2. Description
For indoor/outdoor use like overall maintenance, emergency rescue, camping, night fishing, mobile mechanics, cargo
loading and unloading, tunnel construction, agricultural activities and any other places that need mobile lighting at night.

3. Installation

Mount the unit via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration and
slipping while operating.

4. Operation

Open the protective rubber cap (1) on the lamp and plug one
end of the supplied mains adaptor into the DC socket (1) on the
lamp and the other end into an appropriate wall outlet
delivering a voltage of 220-240Vac 50/60Hz
OR
Plug the DC plug of the supplied cigar lighter plug into the DC
socket (1) on the lamp and the other end into a cigar lighter socket delivering a voltage of 12V or 24Vdc.
Charge the built-in Li-ion battery for about 5-6 hours. During the charging time, you can use the light.
©Copyright LOTRONIC 2014
GB
LF10R 2