Herunterladen Diese Seite drucken

Renkforce 1760693 Bedienungsanleitung Seite 2

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating instructions
PCIe 4x M.2 SSD RAID CONTROLLER CARD
Item no. 1760693
Intended use
The product is intended for installation in a PCIe slot on a computer, where it provides four
SATA ports for the connection of suitable SSDs.
For safety and approval reasons, you must not rebuild and/or modify this product. Using the
product for purposes other than those described above may damage the product. In addition,
improper use can cause hazards such as a short circuit, fire or electric shock. Read the
instructions carefully and store them in a safe place. Only make this product available to third
parties together with its operating instructions.
This product complies with statutory, national and European regulations. All company and
product names included herein are trademarks of their respective owners. All rights reserved.
Delivery content
• PCIe card
• 4x screws
• Screwdriver
Up-to-date operating instructions
Download the up-to-date operating instructions at www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in a triangle indicates that there is a risk to your health,
e.g. due to an electric shock.
The symbol with an exclamation mark in a triangle is used to highlight important
information in these operating instructions that must be observed.
The arrow symbol indicates special information and tips on how to use the product.
Safety information
Read the operating instructions carefully and observe in particular the safety
instructions. If you do not follow the safety information and information on
proper handling in these operating instructions, we will assume no liability for
any resulting personal injury or damage to property. Such cases will invalidate
the warranty/guarantee.
• Electrostatic charges can damage electronic components. Do not touch the
electronic components with your bare hand.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. It may become a
dangerous toy for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Never expose the product to mechanical stress.
• If it is no longer possible to operate the product safely, stop using it and prevent
unauthorised use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stress.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
may damage the product.
• Always observe the safety information and operating instructions of any other
devices which are connected to the product.
• Consult a technician if you are not sure how to use or connect the product, or if
you have concerns about safety.
• Maintenance, modifications and repairs must be carried out by a technician or a
specialist repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
• CD
• Operating instructions
Installing SSDs
If the SSDs already contain data, it is necessary to perform a backup before carrying
out the installation.
• Unscrew the screws and nuts attached centrally in front of the four SATA connection strips.
• Connect your SSDs with the connector strips. Do not use any force.
• Secure the SSDs with the screws and nuts in the appropriate screw hole (2230, 2242, 2260,
2280).
Installing the card in the computer
If you do not have the expertise to perform the installation, please arrange for the
installation to be carried out by an expert or a suitable specialist shop!
In case of improper installation, the product as well as your computer and all
connected devices will be damaged.
Caution, lethal hazard!
Switch off the computer where the product is to be installed and turn off all connected
devices. Disconnect all devices from the mains voltage by pulling out the plug from
the mains socket. Just turning off at the on/off switch is not enough!
• Open the housing of your computer and carefully take off the cover of the housing.
• Locate a free PCIe slot, remove the respective slot cover and insert the PCIe card into the
slot.
• Screw the card firmly in place and make sure it is positioned correctly in the slot.
• Close the computer case.
• Connect your computer and monitor to the mains voltage and switch on all of the devices.
• If your computer does not start correctly, switch it off immediately and check all the settings
and cable connections.
Before opening the computer again, it must be disconnected from the mains voltage,
see above!
Software/driver installation
• Insert the enclosed CD into the corresponding drive on your computer.
• Open the file "MSUSetup.exe" (path: MSU\4.1.0.2018) and follow the instructions on the
screen.
To configure a RAID system, follow the instructions in the main directory of the CD
(file name: se-pcie-m2ssdx4-r-ma user manual.pdf).
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to environmental protection.
Technical data
Slot ............................................... PCI Express (PCIe)
Connections .................................. 4 x SATA 3.0
Suitable SSD ................................ 4 x SATA-based M.2 SSD with B-key and form factor 2230,
2242, 2260, 2280
System requirements .................... Windows
Vista™ (32 bit), 7 (32/64 bit), 8.0 (32/64 bit), 8.1 (32/64 bit),
10 (32/64 bit), 10 S
Operating conditions ..................... 0 to +55 °C, ≤95 % RH
Storage conditions ........................ -20 to +70 °C, ≤95 % RH
Dimensions ................................... 115 x 120 x 20 mm
Weight .......................................... 62 g
PCIe-based SSDs are not supported.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92242 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
XP Home/Pro with SP1/SP2/SP3 (32 bit),
®
*1760693_v1_1118_02_IPL_m_en

Werbung

loading