Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY INSTRUCTIONS
In order to avoid electric shock or other injuries, follow the
safety instructions below:
1. Before using the device, inspect the case for any
mechanical damage. If the case has cracks or is missing
any part, do not use the device.
2. Before using the device, check the test leads for any
insulation damage. If the test leads has insulation damage
or cuts, do not use the device.
3. Do not input voltages higher than said in the specification.
4. During measurements, do not change the position of the
rotary switch.
5. Take extra precaution while measuring voltages above 60
V DC and 30 V AC.
6. Before measurement position the rotary switch to correct
position and connect the test leads to the proper terminals.
7. Do not use the device in temperatures exceeding the
range in specification, in high humidity, and near
explosives and flammables.
8. During measurement, hold the test leads above the finger
guards.
9. Before measurement disconnect the measured circuit from
power and discharge all capacitors.
10. If the display shows low battery icon, change the batteries.
Otherwise the accuracy of measurements may be
decreased.
11. Before opening the battery case disconnect the test leads
from measured circuit and from the device.
12. Battery must be replaced with a new one and with the
same specification.
13. Do not tamper with devices internal circuits. This may lead
to measurement decrease or damaging the device.
14. The device is intended for indoors use only.
15. Take out the batteries, if the device is not going to be used
for a long time.
9
9
EN
DE
Werbung
Inhaltsverzeichnis
