air&me Airom Bedienungsanleitung Seite 9

SWITCHING ON AND OPERATING INSTRUCTIONS
Before switching on the appliance, check
that Airom is unplugged
• Pull off the cover of the appliance (6).
• Fill the built-in water measure inside the
diffuser cover (1) with cold water. It has
a capacity of 75 ml which is exactly the
maximum capacity of the tank (8).
• Pour the collected water in the measure
into the tank(8).
• Add 3 to 10 essential oil drops.
• Replace the cover (6) and then plug the
cord into an electrical socket.
• Airom is now ready to be used.
CAUTION: NEVER EXCEED THE MAXIMUM
FILLING LEVEL OF THE TANK.
• Power button - AiromaWave
Press the left side of the power button once
to switch the appliance on. Then press the
right side of the power button to switch the
AromaWaveTM function on. (See "Power and
function control" on the previous page)
After several seconds, Airom will begin to diffuse
a fine scented mist.
Press a second time on the left side to switch
the appliance off or press a second time the
right side to deactivate the AromaWaveTM
function.
Airom will automatically switch off if the tank is
empty.
• Aroma Wave Function
TM
Alternating 10 minutes of diffusion followed
by 20 minutes of pause - for perfect balance.
The AromaWaveTM function enables not to
load the atmosphere with scented molecule
preventing a perfume habituation. It also
enables a lower consumption of essential
oils. This interval mode allows you to use the
aroma diffuser during an entire day (about
15 hours) against about 5 hours in continuous
use.
10 MIN 20 MIN 10 MIN
AROMAWAVE
Function(3)
TM
20 MIN
DIFFUSION STOP