Sophos SG 550 Montageanleitung

Sliding Rails Mounting Instructions
The rails fit into EIA racks with 5/8" pitch and square holes. Please use the supplied round-hole rack plates in order to
mount them on a rack with round holes.
Step 1:
Remove the Appliance Rail
Pull the slide open. Then push the trigger forward as
shown on the drawing, and pull the chassis (inner)
member out.
Pull inner
member out
Step 3:
Attach the Rack Rails to the Rack
Insert the front and rear brackets into the rack until it
clicks. Make sure that the latch is locked so that the
brackets can't be released.
Push the latch for dismounting the rails.
United Kingdom Sales:
Tel: +44 (0)8447 671131
Email: sales@sophos.com
Boston, USA | Oxford, UK © Copyright 2015. Sophos Ltd. All rights reserved.
All trademarks are the property of their respective owners. 2139.04.15.DD.Simple
Press trigger
forward to
release
North American Sales:
Toll Free: 1-866-866-2802
Email: nasales@sophos.com
SG/XG 550/650
Step 2:
Attach the Appliance Rail to the
Chassis
Mount the slide rails on each side of the appliance by
using at least 3 M4 screws for each side.
Step 4:
Mount the Appliance into the Rack
Insert the chassis (inner) member into the cabinet
member as shown below. While you are pushing the
chassis back to the cabinet, you need to release the slide
from locking position by pushing the trigger forward.
Australia & New Zealand Sales
Tel: +61 2 9409 9100
Email: sales@sophos.com.au