Dehn Blitzductor BXT ML2 BD HF EX 6 Installationsanleitung

INSTALLATION INSTRUCTIONS Blitzductor
Installation / Montage
Blitzductor BXT BAS EX BXT ML2 BD HF EX 6
IECE DEK 11.0078X
Ex ib IIC T4/T5/T6 Gb
KEMA 06 ATEX 0274 X
II 2 G Ex ib IIC T4/T5/T6 Gb
OCP 0004
Standards:
for ATEX: EN 60079- 0: 2012
EN 60079-11: 2012
Certificado N.º: TUV 17.0697X for IECEx: IEC 60079-0: 2011
Ex ia [ia Ga] IIC T6...T4 Gb IEC 60079-11: 2011
Ex ib IIC T6...T4 Gb IEC 60079-26: 2006
Connection with intrinsically
Para conexão para circuitos
intrinsecamente: safe circuits with:
U = 4,2 V U = 4,2 V
i i
I = 4,8 A
I = 4,8 A
i i
P = indeterminada P = any
i i
C = desprezível C negligibly small
i i
L = desprezível L negligibly small
i i
Faixa de temperatura ambiente: Special conditions for safe use
-40 °C ≤ Ta ≤ +55 °C – para T6 The dielectric strength of at least 500 V
-40 °C ≤ Ta ≤ +75 °C – para T5 of the intrinsically safe circuits of the
-40 °C ≤ Ta ≤ +80 °C – para T4 Blitzductor series BXT is limited only by
the overvoltage protection.
Normas Técnicas / Regulamento:
Ambient temperature range:
ABNT NBR IEC 60079-0:2013
ABNT NBR IEC 60079-11:2013 -40°C... +55°C for temperature class T6
ABNT NBR IEC 60079-26:2016 -40°C... +75°C for temperature class T5
-40°C... +80°C for temperature class T4
Portaria INMETRO n° 179 de 18/05/2010
Basic circuit diagram / Prinzipschaltbild
2
1 2 3 4
1
Cable Routing / Leitungsführung
protected protected
® BXT ML2 BD HF EX 6
I
L
2´
4´ 3´ 2´ 1´
1´
Removing the module / Entfernen des Moduls
1
Connection / Anschluss
0.08 - 2.5 mm²
□
≤ 0.4 ≤ 3.5
Nm in-lbs
2.5 0.4
mm mm
LifeCheck
1
2
Basic circuit diagrams / Prinzipschaltbild
2
4
1
3
AWG 28 -14
7 mm
© COPYRIGHT 2017 DEHN + SÖHNE protected by ISO 16016
1695 / 09.17 / 3009201
2´
4´
1 2 3 4 4´ 3´ 2´ 1´
1´
3´
≥ 4 mm²
□
≤ AWG 10
www.dehn.de
www. dehn-international.com