English - Berner BACFL Bedienungsanleitung

E N G L I S H
Congratulations!
You have chosen a Berner tool. Years of
experience, thorough product development and
innovation make Berner one of the most reliable
partners for professional power tool users.
Package contents
The package contains:
1 Flashlight
1 Spare light bulb
1 Instruction manual
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of
non-observance of the instructions in
this manual.
Technical data
Voltage
Illumination
Beam diameter
Weight (without battery pack)
Battery pack (not included)
Voltage
Capacity
EC-Declaration of conformity
BACFL-12V
Berner declares that these Power Tools have
been designed in compliance with: 89/392/EEC,
89/336/EEC, 73/23/EEC, EN 50144, EN 55014.
Mario Ferretti
Chief Executive
Officer (CEO)
Berner GmbH, D-74653 Künzelsau
6
BACFL-12V
V 12
lx 282
cm 62
kg 0,34
121915
V 12
Ah 2,0
Jean-Marie Biren
Chief Operations
Officer Berner (COO)
Safety instructions
Read the following safety instructions before
attempting to operate this product. Keep these
instructions in a safe place!
Remove the battery pack when not in use,
before servicing and when changing
accessories.
Fire hazard! Avoid metal short circuiting the
contacts of a detached battery pack (e.g. keys
carried in the same pocket as a battery pack).
The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin
contact, flush immediately with water. Neutralize
with a mild acid such as lemon juice or vinegar.
In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Consult a
physician.
Never attempt to open a battery pack tor any
reason.
Description (fig. A)
Your Berner Flashlight has been designed to
operate 12V battery packs and can be used as
a handheld model or as a standing model.
1 ON/OFF-switch
2 Battery pack holder
3 Battery pack (not included)
4 Release buttons
5 Bulb
6 Lens holder
7 Swivelling head
8 Bulb storage compartment
Smelling the head (fig. B)
Your Berner Flashlight can be used as a
standing model or as a handheld model.
• Hold the swivelling head (7) in one hand and
hold the back end of the flashlight in the
other
• Swivel the head in the direction of the arrow
(9) until it clicks into position as shown in
figure A.
• If required, swivel the head back into its
original position as shown in figure B.
Replacing the light bulb (fig. A)
• Unscrew the lens holder (6) and remove it.
• Simply pull out the bulb (5) and insert a new
one.
• Reinstall the lens holder (6).
BACFL-12V