Herunterladen Diese Seite drucken

Renkforce 1377598 Bedienungsanleitung Seite 2

Monitor-/studioboxenständer

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating instructions
Monitor/studio speaker stand
Item no. 1377598
Intended use
The speaker stand is designed to secure a speaker with a standard flange of Ø35 mm. The height of
the speaker can be adjusted via the telescopic tube. The speaker stand is designed for an evenly
distributed load of up to 45 kg.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition,
improper use can cause injuries. Read the instructions carefully and keep them. Make this product
available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names
and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• 2 x UV strips
• Tripod
• 2 x Screw M8 x 30
• Mounting plate
• 2 x washers M8
• Telescopic tube
• Cable clip
• Allen key
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on proper
handling in this manual, we assume no liability for any resulting personal injury or
damage to property. Such cases will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
E
D
F
Installation: A – F; Use: 1 – 6
Maintenance and cleaning
• You do not need to carry out maintenance work on the product.
• A dry, soft and clean cloth is sufficient for cleaning.
• Never use aggressive detergents or chemical solutions, as these could damage the metal or
Disposal
• Operating instructions
Technical data
Height ..............................................................70 – 110 cm
Telescopic tube .............................................5 levels
Tube diameter ................................................Ø35 mm (for 35 mm standard flange)
Load capacity ................................................max. 45 kg
Material ..........................................................Steel
Dimensions (W x H x D)................................approx. 43 x 70 x 38 cm (in lowest position)
Weight .............................................................approx. 3 kg
B
C
A
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Be careful not to trap your fingers or other parts of your body when opening, closing
and adjusting the stand.
• Get another person to help you when lifting heavy speakers to avoid injuries
(e.g. back injuries).
• Always secure the load. Do not overload the stand.
• Do not move/lift the stand if there is a speaker attached.
• Maintenance, modifications and repairs are to be performed exclusively by
an expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
impair the functioning of the product.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
6
3
7
V2_0116_02_JH
ø35 mm
5
4
1
2

Werbung

loading