Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(GB) Installation and operating instructions
Technical data:
Voltage:
Number of LEDs:
Operating modes:
Measurements:
Operating temperature:
E- test number
Disposal:
Electronic devices are recycable materials and should not be disposed of with hou-
sehold waste. Dispose of the product at the end of its useful life according to the
applicable regulations.
Copyright by
All rights reserved. It is not permitted without written approval from Berger + Schröter to reproduce these operating instructions. It is
also not permitted to reproduce extracts in any form that have been created or processed by use of electronic, mechanical or chemical
procedures. Technical changes can be made at any time without prior announcement. The operating instructions are corrected regu-
larly. We assume no liability for technical and typographical errors and their results.
LED rotating beacon, flexible foot
Art.-No. 20246
12/24 Volt R65
39 pcs. super bright LED`s
120 all-round flash per minute
Height 19 cm, lamp glass diameter- 12,5 cm,
Height of lamp glass 6 cm
-30°C to +50 °C
E9 10R-05.11190 / E9 00.1824, 19W
IMPORTANT: You require a special permit
according to STVZO §52 to operate the rota-
ting beacon. Please inquire at your road ap-
proval office (traffic authority)
You require a standard base to install the LED-
rotating beacon. The standard bases of the 'old'
rotating beacons without LED technology also
fit.
1. Screw the standard base in a suitable posi-
tion onto the vehicle roof, so that the rotating
beacon can be seen from all sides.
2. Open the clamping screw at the RB and push
the standard base into the holder
3. Tighten the clamping screw.
The lamp glass is opened by turning it slightly
to the left and is closed by turning it slightly to
the right (bayonet catch).
www.berger-schroeter.de
2
Werbung
